Programming; To Add A Remote Control, Keyless Entry, Or Myq; Door Control (Myq ® Control Panel) - LiftMaster ELITE Série Mode D'emploi

Programming

Your hand-held remote control (model 893MAX) has already programmed to the door control (MyQ
are instructions for programming additional remote controls, keyless entries, and MyQ
NOTE: Use the learn button on the door control to program all accessories. The yellow learn button on the garage door opener will NOT
program accessories.

To Add a Remote Control, Keyless Entry, or MyQ

Door Control (MyQ
REMOTE CONTROL
®
1. Press the MyQ Control Panel LEARN button twice,
the red learn LED will turn on.
2. Press the button on the remote control that you
wish to operate your garage door.
3. The garage door opener lights will flash (or two
clicks will be heard) when the code has been
programmed.
MyQ ® ENABLED ACCESSORIES
®
1. Press the MyQ Control Panel
LEARN button twice, the red learn
LED will turn on.
2. Press the LEARN button on the
MyQ ® device.*
LEARN
Button
Model 825LM - Remote Light Control
Light module can be synchronized with
the garage door opener light bulbs.
® Control Panel)
Model 829LM - Garage Door and Gate
Monitor
Indicates the status of your garage door
from inside the home and allows you to
close an open garage door from inside the
house.
® enabled accessories to the door control.
®
Enabled Accessories using the
KEYLESS ENTRY
1. Press the MyQ
red learn LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of
your choice on the keyless entry keypad. Then press
the ENTER button.
3. The garage door opener lights will flash (or two clicks
will be heard) when the code has been programmed.
Command
LED (yellow)
Learn LED
(Red)
LEARN
Button
Model 823LM - Remote Light Switch
Light module can be synchronized with
the garage door opener light bulbs.
* MyQ
26
®
Control Panel) at the factory. Below
®
Control Panel LEARN button twice, the
? ?
PIN
® accessories may be
programmed to the LiftMaster
Internet Gateway (Model 828LM) or
the MyQ ® control panel. For
instructions on programming to the
LiftMaster ® Internet Gateway refer to
the manual.
? ?
LEARN
Button
®