Connect Power - LiftMaster ELITE Série Mode D'emploi

Installation
8

Connect Power

To avoid installation diffi culties, do not
run the garage door opener at this time.
To reduce the risk of electric shock, your
garage door opener has a grounding type
plug with a third grounding pin. This plug
will only fi t into a grounding type outlet. If
the plug doesn't fi t into the outlet you have,
contact a qualifi ed electrician to install the
proper outlet.
There are two options for connecting
power:
OPTION A: TYPICAL WIRING
1. Plug in the garage door opener into a
grounded outlet.
2. DO NOT run garage door opener at
this time.
OPTION B: PERMANENT WIRING
CONNECTION
If permanent wiring is required by
your local code, refer to the following
procedure.
To make a permanent connection through
the 7/8 inch hole in the back of the garage
door opener (according to local code):
1. Be sure power is NOT connected to
the opener, and disconnect power to
circuit.
2. Remove the garage door opener from
the torsion bar, remove cover screws
and set the cover aside.
3. Remove the attached green ground
terminal.
4. Cut black and white wires and strip
away 1/2 inch (1.3 cm) of insulation,
3 inch (7.6 cm) before spade
terminals.
5. Remove the power cord from the
garage door opener.
6. Install a 90° conduit or fl ex cable
adapter to the 7/8 inch hole. Reinstall
garage door opener to torsion bar.
7. Run wires through conduit, cut to
proper length and strip insulation.
8. Attach with wire nuts provided.
9. Properly secure wire under plastic
ties so that wire does not come in
contact with moving parts.
10. Reinstall the cover.
To prevent possible SERIOUS INJURY or DEATH from electrocution or fi re:
• Be sure power is NOT connected to the opener, and disconnect power to circuit
BEFORE removing cover to establish permanent wiring connection.
• Garage door installation and wiring MUST be in compliance with ALL local electrical
and building codes.
• NEVER use an extension cord, 2-wire adapter or change plug in ANY way to make it
fi t outlet. Be sure the opener is grounded.
WRONG
RIGHT
RIGHT
Flexible
Conduit
Ground
Tab
16
IMPORTANT NOTE: The model 580LMC
Alternate Power Supply may be installed
if an outlet is not located near the garage
door opener. MyQ
continue to work however all other MyQ
devices and TTC will not work if using the
Model 580LMC Alternate Power Supply.
WRONG
If you would like to use these features,
contact an electrician to install an outlet
near to the garage door opener.
Green Wire
90˚
Connector
BACK VIEW
Green Ground
Screw
Ground Wire
Black Wire
From Power
Cord
White Wire
From Power
Cord
®
light controls will
®
Black Wire
White Wire