Audio Preset Memory; Audio Preset Recall - Kenwood DPX503 Mode D'emploi

Audio Adjustments
Function of DPX303

Audio Preset Memory

Registering the value setup by Sound Control. The
memory cannot be erased by the Reset button.
1
Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- <Audio Control> (page 22)
- <Audio Setup> (page 23)
2
Select Audio Preset item during Menu
mode (Other than Standby mode)
Select the "Audio Preset" display.
For how to select Function Control items, refer to
<Function Control> (page 6).
3
Enter Audio Preset mode
Press the Control knob for at least 1 second.
4
Select the Audio Preset Memory
Turn the Control knob.
Select the "Memory" display.
5
Determine whether to put the Audio Preset in
the memory
Press the Control knob.
"Memory?" is displayed.
6
Put the Audio Preset in the memory
Turn the Control knob to select "YES", and then
press the Control knob.
"Memory Completed" is displayed.
7
Exit Audio Preset mode
Press the [FNC] button.
⁄
• Register 1 pair of Audio Preset Memory. You cannot
register by the source.
• When you press the Reset, all the sources will be the
setting value which is registered.
• The following items cannot be registered.
Volume, Balance, Fader, Loudness, Volume offset, Dual
Zone System, Rear Volume
24
|
DPX503/DPX303
Function of DPX303

Audio Preset Recall

Recalling the sound setup registered by <Audio
Preset Memory> (page 24).
1
Select the source
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Select Audio Preset item during Menu
mode (Other than Standby mode)
Select the "Audio Preset" display.
For how to select Function Control items, refer to
<Function Control> (page 6).
3
Enter Audio Preset mode
Press the Control knob for at least 1 second.
4
Select the Audio Preset Recall
Turn the Control knob.
Select the "Recall" display.
5
Determine whether to recall the Audio Preset
Press the Control knob.
"Recall?" is displayed.
6
Recall the Audio Preset
Turn the Control knob to select "YES", and then
press the Control knob.
"Recall Completed" is displayed.
7
Exit Audio Preset mode
Press the [FNC] button.
⁄
• The User memory of "SYSTEM Q" in <Audio Control>
(page 22) is changed to the value which was recalled.
• The source tone memory item of <Audio Control> (page
22) is changed to the value which was recalled by the
selected source.