Velleman DVM832 Mode D'emploi page 16

DVM832
16. Troubleshooting
If the device beeps continuously while measuring
continuity, this means that the F500 mA/600 V internal
fuse is defective.
Keep in mind that a low battery level could lead to
incorrect measurements. Replace the batteries on a regular
basis.
Tip: the reduced luminosity of the backlight/LCD display
indicates a low battery level.
Use this device with original accessories only.
Velleman Group nv cannot be held responsible in the
event of damage or injury resulting from (incorrect)
use of this device. For more info concerning this
product and the latest version of this manual, please
visit our website www.velleman.eu. The information
in this manual is subject to change without prior
notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman
Group nv. All worldwide rights reserved. No part of
this manual may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 05 – 05/01/2022 16 ©Velleman Group nv