Velleman DVM832 Mode D'emploi page 15

3. Connect the test leads to two points of the circuit to
be tested. If continuity exists, the built-in buzzer will
sound.
15. Battery Replacement
WARNING: To avoid electrical shock always
disconnect the test leads prior to opening the
housing. To prevent fire hazards, only use fuses
with the same ratings as specified in this manual.
Remark: refer to the warning on the battery
compartment
There are no user-serviceable parts inside the
device.
Refer to an authorized dealer for service and/or
spare parts.
Equipment must be isolated or disconnected from
the HAZARDOUS LIVE voltage before access
(referring to battery replacement by operator).
• When"
replaced.
• Blown fuses almost always result from human error.
To replace the battery:
• Switch of the meter
• Release the screw located at the backside of the meter
and gently open the housing.
• Remove the old batteries and insert new ones.
Battery: 2 x 1.5 VDC AAA/R03P alkaline, do not use
rechargeable batteries and make sure to respect
the polarity
Make sure the meter is closed tight and put the protective
edge back in place before using the meter.
V. 05 – 05/01/2022
DVM832
" is displayed, the battery should be
15 ©Velleman Group nv