Sideguards; One Hand Operation Armpad - Quickie Life i Notice D'utilisation

Sideguards

Central support
Installation: Slide the arm post into the receiver, located on the
wheelchair frame, until it stops
Height adjustment:
Slide the arm rest post out of the receiver.
Adjust the position of the hight adjustment bracket (1) by
removing the screw (2) and moving it to the desired posiion.
Re-fit the screw and tighten it.
Slide the arm rest post back into the receiver, (Fig. 6.31).
Armpad Position:
The armpad position can be adjusted by relesing the screws
(3), then moving the arm pad to the desired position. Re-tighten
the screws, (Fig. 6.31).
Adjusting Armrest Receiver
The tightness of the armrest receiver can be adjusted (tightened
/loosened) by means of the 2 screws (1) - (Fig. 6.32).
Sideguard With Clothes Protector (Fig. 6.33)
The clothes protector prevents clothes getting dirty from spray
water. You can set the position in relation to the rear wheel by
moving the sideguard.
To do this, remove the fixing screws (1 and 2).
After setting to the desired position, re-tighten the screws (see
the page on torque).
WARNING!
Neither the sideguards nor the armrests are to be used for
lifting or carrying the wheelchair
Fig. 6.31
3
1
2
Fig. 6.33
1
22
Fig. 6.32
1
2
STANDARD SIDEGUARD,
SIDE GUARD, FLIP-UP, REMOVABLE WITH SHORT OR
LONG ARMRESTS, HEIGHT-
ADJUSTABLE
WITH SHORT OR LONG
ARMRESTS
The sideguard with rounded off
front edges will allow you to get up
close to a table. To flip the armrest
up, push the lever (1), so that the
sideguard is released (Fig. 6.34
and 6.35).
The height of the armrest (2) can
be adjusted by fitting the
spacer bracket in various
positions. To do this release the
screws, move the spacer bracket
and re-tighten the screws. The
length of the armrest can be
adjusted by releasing the screws
(3), then move the armrest to the
desired position and re-tighten the
screws (Fig. 6.35).
CAUTION:
• Neither the sideguards nor the armrests are to be used for
lifting or carrying the wheelchair.
• Take care of your fingers when adjusting the arm pad height.
SIDE GUARD, FLIP-UP, REMOVABLE WITH SHORT OR
LONG ARMRESTS, HEIGHT-ADJUSTABLE
The armrest can be height adjusted as follows.
Move the lever downwards and move the armrest to the desired
height.
Release the lever and press the armrest downwards until you
hear it click into place. Always check that the sideguards are
correctly engaged.
To flip the armrest up, push the lever
(1) so that the sideguard is released.
The length of the armrest can be
adjusted by releasing the screws (2)
then push the armrest to the desired
position and re-tighten the screws
(Fig. 6.36).
CAUTION:
• Neither the sideguards nor the armrests are to be used for lifting
or carrying the wheelchair.
• When using a 24" (609.6 mm) rear wheel the armpad must be
moved one level up.

One Hand Operation Armpad

By pressing lever (1) the
height can be adjusted with
one hand.
Fig. 6.34
2
1
Fig. 6.35
3
Fig. 6.36
1
2
Life i Rev.6.0