How To Use The Easy Dog Soft Remote Control - Num'axes EASY DOG Soft Guide D'utilisation

Reprogram an EASY DOG receiver collar
The receiver collar can be re-coded indefi nitely, either with the same remote control, or with a new one
(Ref. § Re-coding procedure).

How to use the EASY DOG SOFT remote control

The EASY DOG SOFT remote control is designed to operate with 1 receiver collar.
button: beeper
If you press the "beeper" button
this function: the beeper will continue to sound for as long as the button is pressed.
The central indicator light of the remote control will come on for as long as the button is pressed.
It's up to you to use the beeper depending on the way you want to train your dog.
With the beeper you can:
- send a sound to your dog when it is disobedient,
- draw its attention...
It's very important to always use the beeper in the same way in order not to disturb your dog.
button: high luminosity LED
If you press the button, you will activate a blinking red high luminosity LED on the collar for approximately
8 minutes.
If you press the button again before the 8 minutes are over, you will stop the LED
The central indicator light of the remote control will come on briefl y.
V button: short vibrations
If you press the V button, the receiver collar will emit a short vibration of approximately 1 second.
The central indicator light of the remote control will come on briefl y.
It's up to you to use the vibration depending on the way you want to train your dog.
With the vibration you can:
- send a sound to your dog when it is disobedient,
- draw its attention...
It's very important to always use the vibration in the same way in order not to disturb your dog.
V V V button: long vibrations
If you press the V V V button, the receiver collar will emit a long vibration. The vibration will last for as long
as the button is pressed (but limited to 8 seconds maximum).
Gb - 25
, the receiver collar will emit sound signals. There is no time limit for