Child Safety Devices; Some Cautions - Tecno Air System Tosai SRE 301 Mode D'emploi

CHILD SAFETY DEVICES

Press <CHILD SAFETY> (extinction 3H) key for 3 seconds.
"Child safety" is indicated with beep sound.
Under <ON> operation:
All functions except extinguishment [ off ] key are restricted.
Under <OFF> operation:
All functions except cancellation of child safety system are restricted.
Cancellation of child safety system can be done by pressing <CHILD SAFETY>
key for 3 seconds. "Child safety" indication goes off.
CAUTION!
If any error code is indicated, cancel the child safety system and then follow steps

SOME CAUTIONS

This heater has been designed with an Air-sensor device.
Abnormal conditions of use of your heater (bad ventilation or too small a room) will automatically
provoke the shut-off of your heater and the Air-sensor light will come on.
This heater may not be used in rooms which are hermetically sealed, such as caravans, boats,
passenger compartments of vehicles etc.
−
Use your heater in a room which is properly ventilated and free of inflammable vapours.
−
Each room that the heater is used in must be adequately ventilated (the ventilator window must
have minimum surface area of 50 cm²).
−
Do not use your heater in too small a room : 3000 watts : min 46 M3, 4600 watts : min 71 M3.
−
In case of damage to the power cord, it must only be replaced by a workshop recognized by the
manufacturer (or distributor).
−
Whenever any of these safety systems is triggered, ventilate the room and check and eliminate
the cause, and then reignite. Never disconnect electric parts and never replace it with non
approved parts.
−
Never disconnect neither the valve of the combustion control nor the combustion system.
Always preserve a minimum clearance of 1 meter from other objects
Any tampering with or modification to the safety system is prohibited. Apart from invalidating the
guarantee, this would risk causing a failure of the system which is there for your safety
In case of damage to the power cord, it must only be replaced by a workshop approved by the
manufacturer (or distributor) because some tools are necessary.
AIR-SENSOR DETECTOR
RESTRICTION ON USE
IMPORTANT
DO NOT USE YOUR HEATER IN ROOMS
SITUATED UNDER THE FLOOR LEVEL.
WARNING for the replacement of the power cord
37