Preparation Procedures; Unpacking; Pre-Ignition Preparations And Checkpoints - Tecno Air System Tosai SRE 301 Mode D'emploi

PREPARATION PROCEDURES

Unpacking

Remove a protection sheet on the top.
Open a fuel tank cover, remove the tank
stopper to pull out the tank.
Remove all the adhesive tapes.
Keep the box for the later storage use.
Pre-ignition Preparation and Check Points
Level:
Set the heater at even level.
F
When the heater is located at the positioned level,
F
Auto Shut-off Device may be activated improperly.
When the heater is located at the even level, Auto Shut-off Device will be auto-
F
matically set on.
Power:
Use household currency AC230V-50Hz.
CAUTION!
In case of accidental use of the deteriorated/impure liquid combustible...
Replace whole content in the fuel tank, and remove all the remaining
in the fuel receiver.
remaining liquid combustible for mobile heater of the previous sea-
son;
liquid combustible for mobile heater directly sunlighted, or stored in
the place with high temperature.
liquid combustible for mobile heater kept in a white polypropylene
container, or in an uncapped container for long time.
Always use the proper liquid combustible container.
Impure liquid combustible are:
liquid combustible mixed with even a small amount of any kind of oil
(gasoline, thinner, kitchen oil, lubricant, heavy oil, light oil, etc.).
liquid combustible mixed with water or dust.
liquid combustible that dehydrate chemical agent or combustion im-
proper was added.
Deteriorated/impure liquid combustible will cause imperfect combus-
tion and/or entire system breakdown.
30