Ignition; Turning Off - Tecno Air System Tosai SRE 301 Mode D'emploi

IGNITION

Press <ON> key.
Operation lamp (same as <ON> key) .
The lamp is on under any of the heat power modes.
About 2 minutes later combustion begins and warm air will be generated.
Check the state of the flame through window.
Normal flames:
Blue-color flames with partially red flames tips.
At the minimum power heating burner will turn red without blue flames.
Abnormal flame:
Red-colour flames
[Causes]:
Recoveries]: Ventilate the room to get fresh air.
Unstable flames
[Cause]:
[Recovery]: Stop the operation and consult with local distributor.
Contact your local distributor or your nearest customer service agent if any other
extraordinary flame state is observed.
NOTES!
The heater may not ignite at once when using it for the first time.
It is quite normal that when the Unit is being lit, it makes a low sound of ignition.
Some burning smell may be come out at ignition or extinguishment.
Ventilate the room atmosphere.

TURNING OFF

Press <OFF> key.
Flames go out, and "ON" lamp goes off.
The fan continues to run for about 3 minutes to cool down the Unit.
3 hour extension
After 2 hours and 45 minutes of operation, 3H extension indicator lamp blinks and
beep sound comes on for the duration of 10 seconds or so
Press 3H extension button, and the operation will resume without extinguishing
heater.
If 3H extension button is not pressed, heater will stop automatically after 3 hours
of operation.
3H extension indicator lamp comes on and OFF/ON indicator lamp turns off.
Press 3H extension button, and heater will restart and operate for another 3
hours.
3H extension indicator lamp is off and OFF/ON indicator lamp is on.
CAUTION:
NEVER try to extinguish flames by hitting, shoving or taking out the plug.
Lack of fresh air.
Dust on the intake filter.
Improper air intake because of the heater location
too close to wall or drapes.
Remove dust on the intake filter.
Relocate the heater to proper places.
Stuck fuel flow caused by dirties along pumping system.
34