DeWalt DC308 Mode D'emploi page 32

E N G L I S H
• For cutting curves and pockets, use an adapted
saw blade.
CHECKING AND CHANGING THE SAW BLADE
• Only use saw blades conforming to the
specifi cations contained in these operating
instructions.
• Only sharp saw blades in perfect working
condition should be used; cracked or bent
saw blades should be discarded and replaced
at once.
• Ensure that the saw blade is securely fi xed.
• The saw blade could be hot due to the work
process. So when changing the blade make
sure that it is chilled, cooled off or wear
protective gloves when touching the blade.
Additional safety instructions for battery packs
and chargers
• Make sure that the battery pack is dry and
clean before inserting it into the charger.
• Never carry the charger by its cord. Never pull
the cord to disconnect from the socket. Keep
the cord away from heat, oil and sharp edges.
• Have any damaged or defective cords replaced
by an authorised D WALT repair agent. Never
E
attempt any repairs yourself.
• Do not expose the charger to damp or wet
conditions.
• Do not attempt to charge wet battery packs.
• Never attempt to open a battery pack for any
reason.
• Charge only battery packs with the ratings as
specifi ed in this manual. Do not attempt to
charge non-rechargeable batteries.
• Always follow the instructions in the back of this
manual for battery pack disposal.
• When not in use, chargers and battery packs
must be stored in a dry place and locked up
securely, out of reach of children.
Transporting
D WALT Li-Ion battery packs comply with the
E
necessary testing requirements under the UN
Manual of Tests and Criteria (ST/SG/AC.10/11/
Rev.3 Part III, Subsection 38.3) as referenced in
the UN Recommendations on the Transport of
Dangerous Goods.
30
– The battery packs have effective protection
against internal overpressure and short-ciruiting.
– Appropriate measures have been provided for
prevention of forced rupture and dangerous
reverse current.
– The equivalent lithium content is below the
relevant limit value.
D WALT Li-Ion battery packs are exempted from
E
national and international regulations applicable
to dangerous goods. However, these regulations
become relevant when transporting several battery
packs together.
• Make sure that battery packs are packed
according to the dangerous goods regulations
as mentioned above to prevent short-circuiting.
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack
show the following pictographs:
Read instruction manual before use
See technical data for charging time
Do not expose to water
Do not probe with conductive objects
Do not charge damaged battery packs
Do not use damaged chargers
Charge only between 4 °C and 40 °C
Have defective cords replaced
immediately
Charger problem