GE GUD27GSPMDG Instructions D'utilisation page 17

FINAL SETUP
LEVELING AND STABILIZING
YOUR APPLIANCE
Level
front-to-back
1. Carefully move the appliance to its final location.
Gently rock the appliance into position. It is
important not to damage the rubber leveling legs
when moving your appliance to its final location.
Damaged legs can increase appliance vibration.
It may be helpful to spray window cleaner on
the floor to help move your appliance to its final
position.
NOTE: Do not use washer cover to lift the unit.
2. To ensure the appliance is level and solid on all
four legs, tilt the appliance forward so the rear
legs are off the ground. Gently set the appliance
back down to allow the rear legs to self adjust.
3. With the appliance in its final position, place a
level on top of back part of the washer lid and
check it side to side, then check front to back.
Screw the front leveling legs up or down to
ensure the appliance is resting solid on all four
legs (no rocking or the appliance should exist),
turn the lock nuts on each leg up toward the base
of the unit and snug with a wrench.
NOTE: Keep the leg extension at minimum to prevent
excessive vibration. The farther out legs are extended,
the more the unit will vibrate.
Installation Instructions
Level
side-to-side
2 Leveling Legs
APPLIANCE START-UP
The washer and dryer are now ready for use. See the
Owner's Manual for proper use and care.
REGISTER YOUR NEW APPLIANCE
TO RECEIVE ANY IMPORTANT
PRODUCT NOTIFICATIONS
Please go to www.GEAppliances.com or mail in your
Product Registration Card.
17