Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
QuickStart
Samson AirLine
8. Turn on the connected amplifier or mixer but keep its volume all the way down. Set the output level of your instrument to maximum
and begin playing at a normal performance level while observing the AP1 "TX/Peak" LED. If the LED lights red (indicating a Peak condition)
even with the AP1 Level control fully counterclockwise, engage the 15 dB pad on the transmitter. If not, slowly turn the Level control clock-
wise to the point where the "TX/Peak" LED occasionally blinks red during the very loudest passages, then back it off just slightly. Finally,
raise the level of your connected amplifier and/or mixer until the desired volume is reached.
9. Do a walkaround through the intended area of coverage while observing the receiver's "TX/Peak" LED; it should continue to be lit steadily
green, indicating sufficient RF reception in all areas of coverage. If not, reposition the AP1 or its antennas as necessary.
10. If you hear any spurious noise from the receiver output when the transmitter is turned off, use the supplied plastic screwdriver to adjust
the AP1 Squelch control, slowly turning it clockwise to the point at which the noise disappears.
3
Publicité
Table des Matières
