DeWalt DCD791 Guide D'utilisation page 72

COMPONENTS (Fig. 2)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Trigger switch
B. Forward/reverse button
C. Chuck collar
D. 1/4" (6.35 mm) hex
quick-release chuck
E. Battery release button
INTENDED USE
These impact drivers are designed for professional impact screwdriving
applications. The impact function makes this tool particularly useful for
driving fasteners in wood, metal and concrete. DO NOT use under
wet conditions or in presence of flammable liquids or gases.
These impact drivers are professional power tools. DO NOT let
children come into contact with the tool. Supervision is required when
inexperienced operators use this tool.
Belt Hook (Optional Accessory) (Fig. 2)
WARNING: To reduce the risk of serious personal injury,
place the forward/reverse button in the lock-off position or
turn tool off and disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: Drop Hazard. To reduce the risk of serious
personal injury, DO NOT use the belt hook for tethering or securing
the tool to a person or object during use when elevated.
WARNING: To reduce the risk of serious personal injury, DO
NOT suspend tool overhead or suspend objects from the belt hook.
ONLY hang tool's belt hook from a work belt.
F. Battery pack
G. Worklight
H. Belt hook (optional accessory)
I. Mounting screw
J. Main handle
K. Mode selector
WARNING: To reduce the risk of serious personal injury,
ensure the screw holding the belt hook is secure.
IMPORTANT: When attaching or replacing the belt hook, use only the
screw (I) that is provided. Be sure to securely tighten the screw.
The belt hook (H) can be be attached to either side of the tool using
only the screw (I) provided, to accommodate left- or right- handed
users. If the hook is not desired at all, it can be removed from the tool.
To move belt hook, remove the screw (I) that holds the belt hook
in place then reassemble on the opposite side. Be sure to securely
tighten the screw.
OPERATION
WARNING: To reduce the risk of serious personal injury,
place the forward/reverse button in the lock-off position or
turn tool off and disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 3)
NOTE: For best results, make sure
your battery pack is fully charged.
To install the battery pack (F) into the
tool handle, align the battery pack
with the rails inside the tool's handle
and slide it into the handle until the
battery pack is firmly seated in the
tool and ensure that it does not
disengage.
To remove the battery pack from
the tool, press the release button (E)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
10
FIG. 3
F
E