Operation And Control; Cleaning; Maintenance; Disposal - Baier BSM 2868 Traduction Du Mode D'emploi Original

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
DANGER
Risk of injury due to electric shock.
Î Disconnect the mains plug before carrying out
any work (e.g. changing the stirrer) on the high-
speed mixer.
DANGER
Risk of poisoning due to toxic gases.
Risk of burns and fire due to flammable gases.
Î Do not process liquids or materials with unknown
hazard potential.
Î Observe the instructions for use issued by the
manufacturer of the material to be stirred.
Î When processing plastics, paints, varnishes and
similar materials, do not work near flammable
gases or materials.
Place the container with the material to be stirred
in a firm, stable position.
Choose stirrers suitable for the material to be
mixed.
1
Mount the stirrer, screw the stirrer into the tool
holder (1) up to the limit stop:
Switch on the machine at the ON / OFF switch
and set the speed or gear; if empirical values are
not available, start with the lowest speed or the
1st gear.
Select the gear:
1
/
2
Set the speed (see technical spec-
f
ifications, page 22) at the gear change
knob (2).
NOTE
Changing gear while the machine is running can
cause damage to the drill.
Wait for the machine to completely stop.
| 24 |
5

Operation and Control

Switch on the PRCD switch; only for the
BSM 2868 – 110 V high­speed mixer.
Immerse the stirrer in the material to be mixed.
1
Use the ON / OFF switch (5) to start the motor.
In case of low-viscosity media, immerse the
stirrer completely and start.
f Increase the speed if necessary.
In case of high-viscosity media, immerse the
stirrer by half and at an angle and start.
f Select a low speed.
After ending the mixing process, pull the stirrer
out of the material to be mixed as the stirrer runs
down.
6

Cleaning

DANGER
Risk of injury due to electric shock.
Î Disconnect the mains plug before carrying out
any work on the high-speed mixer.
The machine must be cleaned after each work
session.
Carefully clean the machine and blow out with
compressed air.
Ensure handles are dry and free from grease.
7

Maintenance

DANGER
Risk of injury due to electric shock.
Î Disconnect the mains plug before carrying out
any work on the high-speed mixer.
The high-speed mixer must be serviced at least once
a year. Further, servicing will be necessary depend-
ing on the wear of the carbon brushes.
Only servicing and repair firms authorised by
Maschinenfabrik OTTO BAIER GmbH may carry out
maintenance of the machine. Also ensure that origi-
nal BAIER spare parts and original BAIER accesso-
ries only are used.
8

Disposal

Recycle the machine and its packaging in
an environmentally friendly way in accord-
ance with the provisions applicable in your
country.

Publicité

Table des Matières
loading

Table des Matières