EN
•
Keep the mains power lead away from
rotating insert tools.
If you lose control of the tool, the mains power
lead can be cut or caught and your hand or arm
can be pulled into the rotating insert tool.
•
Never put down the power tool until the insert
tool has come to a complete standstill.
The rotating insert tool can come into contact with
the surface on which the power tool is placed,
which could cause you to lose control of the
power tool.
•
Do not leave the power tool running while you
are carrying it.
Your clothing can get caught by inadvertent con-
tact with the rotating insert tool and the insert tool
can drill into your body.
•
If the machine is switched on, do not direct
insert tools towards your own or other
people's bodies. Do not touch or take hold of
the tools.
2.6.5 Hazards when using and
handling the power tool
•
The approved speed of the insert tool must be
at least as high as the maximum speed given
on the power tool.
Accessories which rotate faster than approved
can break and fly off the tool.
•
Change insert tools carefully and only use the
mounting tools provided, if they are in perfect
condition. Disconnect the mains plug before
changing the insert tool.
Use of the mounting tool provided prevents dam-
age to the power tool and insert tool.
•
Do not expose power tools to extreme heat
or cold.
Mechanical and electrical damage can occur
during extreme heat and/or cold.
•
Allow the insert tools, tool holders and other
parts cool in the immediate vicinity of the
work area after use.
The equipment can be very hot after use. Do not
touch or grip the parts. Risk of injury.
•
Additional signs or other, non BAIERspecific
parts may not be screwed or riveted onto the
motor, handle, gearbox or protective housing.
This could damage the power tool and cause
malfunctions to occur.
•
Avoid unnecessary noise emissions.
•
Note and follow the safety and work
instructions for the accessories used.
| 20 |
•
When switching on and while working with the
power tool, hold onto it tightly at both handles
and place your body and arms in a position in
which they can absorb the kickback forces or
reaction torque on starting up.
The person using the tool can control the kick-
back and reaction forces by taking suitable
precautions.
2.6.6 Service / Maintenance / Repair
•
If the power tool is dropped or becomes wet,
have it checked.
A possibly damaged power tool is dangerous and
no longer safe to operate. Before using the power
tool again, have it checked by our customer
service or an authorised service centre of
Maschinenfabrik OTTO BAIER GmbH.
•
Repair and maintenance work may only be
carried out by an authorised workshop of
Maschinenfabrik OTTO BAIER GmbH.
Otherwise, all liability and warranty claims against
Maschinenfabrik OTTO BAIER GmbH expire.
NOTE
If using new carbon brushes, do not overload the
machine during the first 10 minutes of operation.
•
Ensure that original BAIER spare parts and
original BAIER accessories only are used
when needed.
Original parts are available from authorised deal-
ers. Use of non original parts can cause dam-
age to the machine and an increased risk of
accidents.
•
Regular servicing by Maschinenfabrik OTTO
BAIER GmbH or a servicing and repair
company authorised by us is specified.
Many accidents are caused by poorly serviced
and maintained power tools.