Design Of The Spray Gun; Intended Use; Safety Instructions - SATA jet 4000 B Mode D'emploi

Operating instructions SATAjet 4000 B RP/HVLP (DIGITAL)
4.

Design of the Spray Gun [1]

[1-1] Spray gun handle
[1-2] Trigger
[1-3] Nozzle set consisting of air
cap, fluid tip (not visible),
paint needle (not visible)
[1-4] Spray gun connection with
QCC
[1-5] Gravity flow cup connection
with QCC
[1-6] Paint strainer (not visible)
[1-7] Gravity flow cup
[1-8] Gravity flow cup lid
[1-9] Anti-drip device
[1-10] Round/flat spray control
5.

Intended Use

The spray gun has been designed for the application of paint, lacquer and
other sprayable media by means of compressed air on suitable substrates
and surfaces.
6.

Safety Instructions

6.1. General Safety Instructions
• Before using the spray gun, please read all safety and the operating
instructions carefully. Safety instructions and indicated safety mea-
sures are mandatory.
• Please keep all enclosed documents and make sure that the spray
gun is handed over only together with these documents.
[1-11] Material flow control screw
[1-12] Material flow control counter
[1-13] Air micrometer (air flow
[1-14] Air micrometer (air flow con-
[1-15] Air piston (not visible)
[1-16] Compressed air connection
[1-17] ColorCode-System (CCS)
[1-18] Front cover plate of the
[1-19] Pressure display (only with
Danger! Notice!
nut
control)
trol) locking screw
pressure display (only with
DIGITAL)
DIGITAL)
US
473