Beem Samowar 2017 Notice D'utilisation page 23

EN
Heating water
CAUTION
► Make sure that the rotary knob (8)
is turned to the Off position. Then
insert the plug into the mains socket.
To heat up water, proceed as follows:
Fill the water tank with the desired
‹
quantity of fresh water. Pay attention
the maximum filling level (15).
Close the lid of the water tank and
‹
subsequently put the teapot on top
of it.
Turn the rotary knob clockwise until
‹
the desired setting is reached.
The thermostat allows individual setting
of the water temperature. You have the
choice between the following settings:
warm, hot, boiling water and intermittent
boiling as described in the section Rotary
knob (page 20).
Boiling
If you turn the rotary knob (8) until it stops
at the the BOIL position, the water is
boiled quickly. If you leave the switch at
this position, the water will continue boiling
until it has completely evaporated.
BEEM - Elements of Lifestyle
Intermittent boiling
After the water has boiled, turn the rotary
knob (8) back until the indicator light (11)
extinguishes. This switches the appliance
to intermittent boiling. The appliance then
switches itself on again and starts heat-
ing when the water temperature drops.
The thermostat then controls the power
supply as required and saves energy. The
thermostat cycle switches the indicator
light (11) on and off.
Refilling with water
WARNING
Filling up the hot container can cause
steam to escape and lead to scalding!
► Turn the rotary knob (8) clockwise until
it stops at the Off position.
► Allow the appliance to cool down for a
few minutes before refilling with water.
NOTE
► If you forget to fill with water, the
boil-dry protection will switch off the
appliance.
► Then fill the appliance again with
water.
Samovar 2017
21