Maintenance And Cleaning - IKA KS 4000 i control Mode D'emploi

"Watchdog"– Mode 2
If an interruption in data transmission occurs which is longer
than the preset watchdog time, the speed setpoint value will
be set to the WD safety speed setpoint and the temperature
setpoint will be set to the WD safety temperature setpoint.
The PC 2 warning message will be displayed.
Connections between shaking instrument and external
devices
PC 1.1 Cable
Cable PC 1.1 for connection to the 9-pin socket on the compu-
ter.

Maintenance and cleaning

The shaker KS 4000 i control and KS 4000 ic control is mainten-
ace-free. It is subject only to the natural wear and tear of com-
ponents and their statistical failure rate.
Examine in regular intervals the functionality and the correct
attachment of the two gas-filled supports!
When ordering spare parts, please give the manufacturing
number shown on the type plate, the machine type and
the name of the spare part.
Please send in equipment for repair only after it has been cle-
aned and is free from any materials which may constitute a
health hazard. Use only cleansing agents which have been
KS 4000 i 1208
approved by IKA to clean IKA devices.
To remove use:
Dyes isopropyl alcohol
Construction materials water containing tenside / isopropyl alcohol
Cosmetics water containing tenside / isopropyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
For materials which are not listed, please request information
from IKA. Wear the proper protective gloves during cleaning of
the devices.
Electrical devices may not be placed in the cleansing agent for
the purpose of cleaning.
Before using another than the recommended method for clea-
ning or decontamination, the user must ascertain with the
manufacturer that this method does not destroy the instru-
ment.
Collecting tray with drain hose (for picture see below)
(applies to KS4000 i control and KS4000 ic control)
In the event of glass breakage, leaking liquid is collected by the
collecting tray below the shaking table and guided to the drain
hose via a drain at the rear.
1. Remove drain hose
from bracket
2. Place drain hose
in laboratory drain
29