Mcacc - Pioneer VSX-S520D Mode D'emploi

> Before Start > Part Names

MCACC

1
TV's remote controller
56
> Install > Initial Setup
2
> Playback
Supplementary information |
Setup the speakers automatically or make desired changes to the equalizer. You can also
check the values set currently for each speaker setting.
1. Switch the input on the TV to that assigned to the unit.
2. Press on the remote controller to display the Home screen, then select MCACC with
the cursors on the remote controller and press ENTER.
3. Select the item with the cursor  /  / /  buttons of the remote controller and press
ENTER to confirm your selection.
0 Change the initial values for each of the settings with the cursors /.
0 To return to the previous screen, press
4. To exit the settings, press .
Full Auto MCACC
Place the supplied speaker setup microphone in the listening position, measure the test
tones emitted by the speakers, then the unit automatically sets the optimum volume level for
each speaker, the crossover frequencies, and the distance from the listening position. This
also automatically adjusts the equalizers for the speakers and enables correction of
distortion caused by the acoustic environment of the room.
Refer to "1. Full Auto MCACC" (P20) in Initial Setup for details.
Manual MCACC
∫ EQ Adjust
If you perform Full Auto MCACC then settings are automatic, but you can also adjust the
output volume of the range of each connected speaker to suit your own preferences. You
can adjust the volume of the different sound ranges for each of the speakers. You can set
three different equalizers in Preset 1 to 3. You can select up to 4 bands for the Subwoofer
and 9 bands for all other speakers. To use the set equalizer effects, select the preset number
Advanced Setup
.
| Others
E
N