Bosch ART 23 LI Notice Originale page 22

OBJ_BUCH-520-001.book Page 22 Thursday, November 15, 2007 2:54 PM
22 | English
Switching Off
Release the On/Off switch 1.
Note: There is a short delay in the motor starting
after engaging the on/off switch 1.
Adjustment
Using the Adjustable Handle
The adjustable handle 5 can be set in various po-
sitions:
To change the position, loosen the handle
screw 4 and move the adjustable handle 5.
Tighten the handle screw 4 securely to fix the
adjustable handle 5 in the adjusted position.
Adjusting the Trimmer Length
Turn the adjusting collar 6 by 90°.
Pull the shaft out to increase the height, or
push the shaft in to decrease the height. Re-tight-
en the adjusting collar 6.
Adjusting the Trimmer-head Angle
To change the cutting angle, press the foot pedal
12 down and move the shaft 7 to the requested
position.
Release the foot pedal 12.
Adjusting for Edging Mode
Adjusting the trimmer-head angle:
H
Press the foot pedal 12 down.
Move the shaft 7 to the lowest position. Re-
lease the foot pedal 12 again.
Moving the trimmer head:
I
Loosen the adjusting collar 6.
Turn the shaft 7 by 90° to adjust the trimmer
head 9 for trimming/edging as shown. Re-tighten
the adjusting collar 6.
F016 L70 510 | (15.11.07)
Working Advice
Cutting Grass
E
Move the cordless trimmer left and right, keeping
it well away from the body.
The trimmer can efficiently cut grass up to a
height of 15 cm. Cut higher grass in stages.
Trimming Edges
Guide the cordless trimmer along the edge of the
lawn. Avoid contact with paved surfaces, stones
F
or garden walls, as this will wear the blade rapid-
ly.
For better control, use the plant protector 18
K
(accessory) as a guide.
Cutting Around Trees and Bushes
G
Carefully cut around trees and bushes so that
they do not come into contact with the blade.
Plants can die if you damage the bark.
For better control, use the plant protector 18
K
(accessory) as a guide.
Battery Duration
The battery duration is dependent on the work-
ing conditions:
Protect the battery from heat, for ex-
ample, also the continuous exposure
to sun radiation and fire.
Product will not function if tempera-
ture is below 0 °C or above 45 °C!
J
Light conditions:
up to 800 metres (ART 23 Li)
up to 1000 metres (ART 26 Li)
Medium conditions:
up to 350 metres (ART 23 Li)
up to 440 metres (ART 26 Li)
Tough conditions:
up to 60 metres
up to 75 metres
Bosch Power Tools
L
(ART 23 Li)
(ART 26 Li)