Hama 186332 Mode D'emploi page 6

Note - Permanent backlight mode
Permanent backlight mode is only possible when plugged into
mains power.
• Press the SNOOZE/LIGHT button (11) several times to change
the brightness level (high/low/off).
5.6. Projection
Activating/deactivating
Power from batteries:
• Press the LIGHT-SNOOZE button (11) to project the display onto
the wall or ceiling for 8 seconds.
Power from power supply unit:
• Press and hold the SNOOZE/LIGHT button (11) for
approximately 3 seconds to activate sustained projection.
• Press and hold the SNOOZE/LIGHT button (11) for
approximately 3 seconds to deactivate sustained projection.
Projection setting
• Turn the projection arm (10) forward/back to project the display
onto the desired wall/ ceiling.
• Press the ROTATE button (19) again to rotate the projection by
0°, 90°, 180° or 360°.
6. Charging function
Warning - Connecting terminal devices
• Before connecting a terminal device, check whether the
power output of the charger can supply sufficient power for
the device.
• Ensure that the total power of all connected terminal devices
does not exceed 10 W
• Please refer to the instructions in the operating manual of
your terminal device.
Note
The charging function is only possible when plugged into
mains power.
• Connect your terminal device to a USB charging socket (22) on
the alarm clock using a suitable USB cable.
• The charging progress is displayed on your terminal device.
• Disconnect the terminal device from the USB charging socket
if you want to interrupt charging or if the terminal device is
fully charged.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents. Make sure that water does not
get into the product.
Note
Disconnect the device from the power supply before cleaning it
or if it is not going to be used for a long period of time.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
9. Technical Data
RCR 110 radio-controlled alarm clock
Power supply
Measuring range
for temperature
Humidity
measuring range
10. Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio
equipment type [00186332] is in compliance with
Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet
address: www.hama.com -> 00186332 -> Downloads.
Frequency band(s)
5.0 V
2 x AAA batteries
Power supply unit:
In: 100 – 240 V 50/60 Hz
Out: 5 V 2.5 A
-9° C - + 50° C / 14° F - +122 °F
20 % - 95 %
77.5 kHz
5