Fuses Screen - Dometic PCD5501 Manuel D'utilisation

Dometic Interact
31 Programs Screen
The Programs screen is the main screen from which pre-
configured programs and scenes can be monitored,
enabled, or disabled. You can complete the following
actions from this screen:
• Tap the star icon to open the Programs screen.
• Tap the exit (x) icon to close the Programs screen and
return to the previous screen.
• Tap any program button to start running the program.
• Rain: The button closes the lids of both the vent fans.
• Fresh Air: The button opens the lids of both vent fans.
• INT Lights On: The button turns all the interior lights
ON.
• INT Lights Off: The button turns all the interior lights
OFF.
• EXT Lights On: The button turns all the interior lights
ON.
• EXT Lights Off: The button turns all the interior lights
OFF.
• Wake Up: The button turns the Accent, Galley, and
Bed ceiling lights ON.
• Good Night: The button turns ALL the lights OFF.

4.1.11 Fuses Screen

The Fuses screen allows you to monitor and control the
software fuses for the various system components.
EN
A software fuse will display as "blown" if the load draws
more current than the allowed limit.
32 Fuses Screen
Each controlled component includes a toggle button
indicating the fuse status: OK or blown.
When the system detects a high inrush current or over-
voltage condition, the software blows the fuse for that
particular output.
Use the toggle button to reset a blown fuse, which sets it
to the enabled (OK) state.
When a fuse blows, the system produces a notification by
showing a number beside the bell icon at the top of each
screen. The system also plays a sound to notify you.
The number on the notification bell icon remains until you
open the Notifications screen and close all notifications,
one-by-one.
Refer to the Notifications Screen section for more
information.
Operation
21