Tanks Screen - Dometic PCD5501 Manuel D'utilisation

Dometic Interact
From this screen, you can control and monitor the
following functions:
• Auto Charger: Use this toggle button to enable or
disable the auto charger. The auto charger is disabled
by default. When you enable the auto charger, a pop-
up message appears.
15 Ventilation Alert
The AGS becomes disabled if the ignition is turned on.
If you attempt to enable the auto charger while the
ignition is on, a pop-up message appears.
16 Ignition Alert
The following auto charger settings are available:
– Quiet Time: Use the available tumblers (hour and
minute) to set the desired quiet time start and end
times. The generator is turned off automatically
during the specified quiet time.
– Start Voltage: Use the tumbler to set your desired
voltage setting (10 V–12.9 V). The default setting is
10.5 V. The Start Voltage tumbler controls the
threshold voltage under which the AGS must
turn on.
– Time Under: Use the tumbler to set your desired
timer setting (0–10 min). The Time Under tumbler
specifies the timer delay before the AGS starts,
when the system drops below the set threshold
voltage.
• Climate AGS Mode (AGS Climate): These options
enable the climate controls to run the air conditioner
and heat pump off the generator when no shore power
is available.
EN
• Generator Exerciser: Use the toggle button to
enable or disable the generator exerciser.
When you enable this setting, the Ventilation Alert
pop-up message appears. The alert message does not
appear when the generator activates based on the set
schedule. The generator runs as scheduled if the
ignition is turned off. If the ignition is turned on during
a particular day that the generator is scheduled to run,
it would skip running the generator that day unless the
ignition is turned off.
The available generator exerciser settings are:
– Days: Tap the desired days to specify the days on
which the generator exerciser should run.
– Run Time: This tumbler controls the duration for the
generator exerciser. Use the tumbler to set your
desired time setting (0–1250 min).
– Start Time: These tumblers control the time at
which the generator exerciser should start. Use the
available tumblers (hour and minute) to set your
desired time settings.

4.1.8 Tanks Screen

The Tanks screen allows you to monitor and control the
holding tanks, such as the fresh, gray, and black water
tanks.
17 Tanks Screen
Operation
15