Marking And Identification; Mounting Of The Hose - Faicom VG101908GO Notice D'utilisation Et D'entretien

6 - MARKING AND IDENTIFICATION

Model
Features
AVVOLGITUBO per Aria - Acqua
2018 / S.N.1078
Year of
construction
7 - MOUNTING OF THE HOSE (Models without hose)
WARNING! DO NOT PUT HANDS OR ANY OTHER THING INSIDE THE DRUM!
7.1
7.2
BP
7.2
AP
7.3
TORINO RENATO - BUSCA (CN)
VG101908
8 m, 19x27, 10 bar
HOSE REEL for Air - Water
Serial
Number
The hose reels without hose are supplied with the unloaded spring.
Use a hose with dimension and pressure characteristics suitable for use
according to the hose reel model.
Normally, the hoses must be connected Female Straight Gas, except for tho-
se to be used for the following fluids which must have these characteristics:
-Diesel fuel: antistatic hose (R<1 mΩ/m). Hose without fitting.
-Urea / Cold water: Hose without fitting.
-Oil (3/4"): EN857 1SC hose with fitting F.90° 3/4"G.
-Oil (1"): EN857 1SC hose with fitting F.S.1"G.
-Water 400bar (1/2"): EN857 2SC hose with fitting F.90° 1/2"G.
7.0) Fix the hose reel to the bench and remove plastic protection.
7.1) For models with hose <5/8": Put the hose between the guide rollers,
connect it to the fitting which is inside the drum and tighten by the
suitable wrench.
7.2) Models Low Pressure 3/4"-1"(LP): Fix the hose clamp and adjust it
so that during rotation the hose reel is free to turn.
Models High Pressure 1"(HP): connect the hose (A) to the curve,
tightening with the suitable wrench. Tighten the nut (B) on the con-
nection of the drum.
7.3) Insert the hose onto the hose and tighten the nut.
7.4) Mount the lateral protection and rotate manually the drum in order
to rewind completely the hose.
7.5) Spring Preload: hold the hose-end and rotate the drum in the opposite
direction for a few laps, refer to the tables p.38-39.
7.6) Insert the hose-end between the guide rollers and put the hose
rubber stopper at the desired length.
7.7) Unwind the hose and rewind it completely, to check if the hose reel
works properly.
7.4
- 10 -
We affix the CE marking as the
manufacturer of this equipment.
On the equipment is securely
attached a tag with curing adhe-
sive system on which, in addi-
tion to the name of the manufac-
turer and the symbol "CE", all
necessary information for good
identification of the machine are
indicated (model, duty, year of
construction, weight, etc.).
20
Weight
7.5
7.6
WARNING!
DO NOT PUT
HANDS OR ANY
OTHER THING
INSIDE THE DRUM!