Large Envelopes & Flats; Thick Envelopes And Flats; Adjusting Foam Holder And Track Finger For Thick And Thin Envelopes - quadient IM-20 Guide Utilisateur

3.4 Large Envelopes & Flats
3.5

Thick envelopes and flats

Most envelope sizes are fed automatically, requiring the operator to merely add and
remove the mail. For a few thick envelopes, it may be required for the operator to lightly
press on stack to help feed the envelopes. However, if a majority of the envelopes are
thick, the operator may have to adjust the machine settings to allow for efficient and
steady feeding and prevent jamming. This procedure can be seen on the following page.
3.6 Adjusting Foam Holder and Track Finger for Thick and Thin
Envelopes
To perform this step, you will need a small Philips screwdriver. To begin, ensure that the
machine is unplugged, then simply open the Track Cover so that it is freestanding
vertically. In front of the Milling Cutter is a small piece of grey foam, and below that a thin
metal strip. These are the Foam Holder and Track Finger, respectively. The four mounting
screws located above the track finger and Foam Holder will need to be loosened. After
this, simply slide the Foam Holder and Track Finger up as shown. Tighten screws and
make sure area is clear of tools or parts and then close the Track Cover. For thin
envelopes, it is desirable to have less pressure on the envelope at the Foam Holder. Too
much pressure on the envelopes may cause them to crumple up. Follow the previous
procedure to lighten the amount of pressure delivered by the Track Finger and Foam
Holder.
Track Finger
6
Folding the tray open allows easy feeding
and support of large envelopes and mailing
flats.
Foam Holder