DeWalt D55145 Mode D'emploi page 25

Tank volume
Air displacement
Free air delivery
Hot temperature warning
Do not touch hot parts of the unit
Do not stand on top of the unit
Drain the tank
Tank pressure gauge
Air pressure adjustment knob
Air pressure gauge
Read the instruction manual before use
Safe use warning
Package contents
The package contains:
1 Air compressor
1 Wheel set
1 Handle grip
1 Foot
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurredduring transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your air compressor D55145 has been designed for
the production and supply of compressed air in
professional applications. The unit is intended for
intermittent use in light applications, with tools such
as finish nailers and brad nailers.
1 On/off switch
2 Air pressure adjustment knob
3 Hose connector
4 Air pressure gauge
5 Tank pressure gauge
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2),
blue is for Neutral (N) (4) and green/yellow is for
Earth (E).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the leads
are correctly fixed at the terminal screws.
E N G L I S H
25