Safety; Designed Use; Predictable Misuse; Responsibilities - TE Connectivity AT-SC MK II Mode D'emploi

1-528050-0
4

Safety

4.1

Designed Use

- Realization of crimp connections up to a cable Ø of 50 mm² depending on the terminal design.
The maximum processing wire cross section is depending on the application (terminal and wire) with the
released adapters (see chapter 9.1).
For standard applications there are the following benchmarks (exceptions possible):

Insulated terminals 0,25 to 6,0 mm²

Non-insulated copper tube- & sheet terminals 0,5 to 16,0 mm² (one sided W and indent crimp only)

Non-insulated copper tube terminals and butt splices 1,0 to 6,0 mm² (hex crimp)

Insulated and non-insulated ferrules 0,14 to 50,0 mm²

Screw machined contacts 0,14 to 16,0 mm²

Non-insulated Faston quick disconnect 0,14 to 6,0 mm²
The pneumatic Parallel Crimp Machine AT-SC MK II is designed for usage with the adapters described in
chapter 9.1. The adapters should only be used with the dies specified by TE. It is only allowed to use the
pneumatic Crimp Machine AT-SC MK II together with the adapter and die sets for the preparation of
crimp connections!
4.2

Predictable Misuse

- Every application which is not mentioned in chapter 4.1 „Designed Use".
4.3

Responsibilities

The user of the pneumatic Parallel Crimp Machine AT-SC MK II is responsible for making sure that all
persons involved in any way, either in the installation or in maintenance of the machine, have been
thoroughly trained on the system using the this operating Instruction.
The user is also responsible for the training of operators and the instruction must include the following
aspects:
- Purpose of the machine
- Hazard zones
- Safety rules and regulations
- Functionality of the various components of the machine
- Proper operation of the machine
To assure full familiarization with the system, the training must be conducted in the native language of the
operators involved.
Staff qualifications required in conjunction with the use of the pneumatic Parallel Crimp Machine
AT-SC MK II:
Installation
Set-up
Instruction
Operation
Maintenance
Service
The safety instructions, warnings and precautions contained in the individual chapters must be strictly
observed by all users and operators.
Technical personnel with language proficiency in either English or German, in
addition to the native language of the operator.
Through qualified personnel trained as indicated above.
Technical personnel with proficiency in English or German.
Page 40 / 94
412-94233 REV. D1