Basic Safety Instructions; Responsibilities; Notes On Setting Up And Operating The Machine; Notes On Service And Maintenance - TE Connectivity AT-SC MK II Mode D'emploi

1-528050-0
2

Basic Safety Instructions

The pneumatic Parallel Crimp Machine AT-SC MK II has been constructed according to state-of-the-art
technology and the acknowledged technical safety regulations.
When carrying out jobs such as installation, putting the machine into operation or setting it up, operation,
changing the conditions of use and the mode of operation or carrying out maintenance and service jobs, it
is important to observe the procedures for switching off the machine described in the operation
instruction.
RoHS Information
The pneumatic Parallel Crimp Machine AT-SC MK II complies with the EG-Guideline 2011/65/EU
(RoHS 2).
CE
The pneumatic Parallel Crimp Machine AT-SC MK II is CE compliant.
2.1

Responsibilities

The pneumatic Parallel Crimp Machine AT-SC MK II may only be operated by suitably trained and
authorized personnel. The user must clearly define and observe the responsibilities of the personnel for
operation, set-up, maintenance and service. It is particularly important to define who is responsible for
work on the pneumatic equipment. Such work should only be carried out by specially trained staff.
Should the user make any changes to the machine without consulting the manufacturer or the supplier,
the latter will not be liable for any damage that may result.
2.2

Notes on Setting Up and Operating the Machine

The pneumatic Parallel Crimp Machine AT-SC MK II may only be set up and operated in perfect technical
condition, observing all the safety regulations and considering any possible dangers.
Before commissioning the machine, it is always important to check whether all safety devices are
functioning correctly and whether the adapter and the die set are mounted. The housing and the covers in
particular may only be removed by specially trained personnel.
If you suspect that the machine cannot be operated safely, it must be switched off and secured against
anyone accidentally switching it on.
The machine may only be used for the purpose specified in the operating instruction. The manufacturer
and supplier will not be liable for any damages, which may result due to the machine being used for a
purpose other than that for which it was intended. This is done entirely at the user's own risk.
2.3

Notes on Service and Maintenance

It is absolutely essential that machine and equipment parts, on which maintenance or service jobs have to
be carried out, are disconnected from the air supply, unless anything to the contrary is stated in the
operating instruction.
Page 38 / 94
412-94233 REV. D1