Faults; Repair; Disposal - Simco HDC Notice D'utilisation

9. Faults

Problem
No charging
Insufficient charging
Spark-over from charging
bar to material
Table 1: faults

10. Repair

Warning:
− Repairs shall be made by a skilled electrical engineer.
− When carrying out work on the equipment: De-energise the equipment.
Except for the cable protection the charging bar does not have any parts which may be replaced by
the customer. SIMCO recommends to return defective bars.
Pack them properly and clearly state the reason for return.

11. Disposal

Adhere to the applicable local environmental and other rules when disposing of the product.
HDC/HDR 97.52.09.28.10
Cause
High voltage power unit not
switched on
High voltage power unit
defective
HV cable interrupted
High voltage set too low
Charging current not set or
set too low
Distance from charging bar
to material too large
Charging bar fouled
High voltage set too high
Distance from charging bar
to material too small
17
Remedy
Switch on the high voltage
power unit
Repair the high voltage
power unit
Restore HV cable
Raise high voltage
Set (or raise) charging
current
Mount the charging bar
closer to the material
Clean the charging bar
Lower high voltage
Mount the charging bar
farther away from the
material
09/03