Tilting The Projected Images To The Right Or Left - Epson ELPMB26 Guide De L'utilisateur

Procedure

Tilting the Projected Images to the Right or Left

When the projected image is tilted to the right or left compared to the screen, tilt the
projector ±5 degrees to adjust the projection position according to the following steps.
Warning
vNever loosen or remove any screws needlessly when adjusting the angle.
Doing so could cause the projector to fall and lead to an accident.
vRetighten all screws and make sure that they are not loose after adjustment.
Procedure
30
A
Loosen the screws for the vertical angle
adjustment points on both sides using
the M8 hexagon wrench.
B
Tilt the rear of the projector vertically to
adjust the angle until the position of the
projected images fits the screen.
C
After adjusting the angle, secure the
screws on both sides using the M8
hexagon wrench.
A
Loosen the screws for the horizontal roll
adjustment points on both sides using
the M8 hexagon wrench.
B
Tilt the projector to the left or right to
adjust the angle until the position of the
projected images fits the screen.
C
After adjusting the angle, secure the
screws on both sides using the M8
hexagon wrench.