Transport Of The Pressure Sprayer; Cleaning And Care; Clean The Pressure Sprayer; Cleaning The Hose And Pump - Parkside HG01829 Instructions D'utilisation Et Consignes De Sécurité

Transport of the
pressure sprayer
Transport the pressure sprayer
as follows:
Transport during use
H ang the pressure sprayer with the
carrying strap
6
Note: Make sure that the pressure
sprayer is always in an upright position.
Only then can the pressure sprayer func-
tion properly.
Transport after use
P ress the pump handle
it clockwise.
P ull the safety valve
as it will release the residual pressure in
the container
5
C arry the pressure sprayer by the pump
handle or using the carrying strap
1
Note: To avoid damage to the container
during transport, always lift the pres-
5
sure sprayer and do not drag it across
the ground.

Cleaning and care

I f the nozzle seems to be blocked, do
not try to blow it free with your mouth.
Note: Clean the pressure sprayer after each
use! Empty the bottle after each use.

Clean the pressure sprayer

U nscrew the spray nozzle
C lean the spray nozzle
water.
18 GB/IE
over your shoulder.
down and turn
1
to the side as far
3
.
6
.
7
under running
7
I f the spray nozzle
the nozzle
7
through it.
F lush through the pressure sprayer, hoses
and tubes with water.
C lean the surfaces of the product with
a moist cloth.

Cleaning the hose and pump

To clean the parts, follow these steps:
Loosen the union nut (Hose)
hose on the handle
12
hose connection on the cover
Turn the pump handle
wise. Loosen the pump
from the cover
Clean the hose
under running water.
After cleaning, reinsert the pump
. the opening provided for this purpose on
the cover
14
the container
Fasten the hose
tion on the cover
of the spray tube
Tighten the union nut (Cover)

Store the pressure sprayer

Release any residual pressure still pre-
sent in the container after use. To do this,
pull the safety valve button to the side
until you can no longer hear the hiss of
escaping air.
Thoroughly clean the device and allow
it to dry before you put it away for the
winter. This will avoid frost damage.
F old the foot step by pressing the "PUSH"
button before transport the product.
is clogged, clean
7
by pushing a needle
on the
10 b
and on the
11
.
14
counterclock-
1
and pull it out
2
.
14
and the pump
12
2
and screw this back onto
.
5
onto the hose connec-
12
and the handle
14
once more.
8
securely.
9
2
into
11