Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
aware of warning signals or shouts when
you are wearing hearing protection. Always
remove your hearing protection as soon as
the motor stops.
WARNING: There is always a risk of crush
injuries when working with products
containing moving parts. Wear protective
gloves to avoid body injuries.
WARNING: Sparks may appear and start a
fire when you work with the product. Always
keep fire fighting equipment handy.
You must use approved personal protective equipment
when you use the product. Personal protective
equipment cannot eliminate the risk of injury but it will
reduce the degree of injury if an accident does happen.
Ask your dealer for help in choosing the right equipment.
Always wear:
•
Approved protecting helmet.
•
Hearing protection.
•
Approved eye protection. If you use a face shield
then you must also wear approved protective
goggles. Approved protective goggles must comply
with standard ANSI Z87.1 in the USA or EN 166 in
EU countries. Visors must comply with standard EN
1731.
•
Approved respiratory protection.
•
Protective gloves.
•
Heavy-duty, firm grip gloves.
•
Tight-fitting, heavy-duty and comfortable clothing
that permits full freedom of movement. Cutting
generates sparks that can ignite clothing. Husqvarna
recommends that you wear flame-retardant cotton or
heavy denim. Do not wear clothing made of material
such as nylon, polyester or rayon. If ignited such
material can melt and cling to the skin. Do not wear
shorts.
•
Boots with steel toe-caps and non-slip sole.
Always have a first aid kit and firefighting equipment
nearby.
Safety devices on the product
WARNING: Read the following warning
instructions carefully before using the
product.
8
Power switch
Press the power switch to start the power cutter and
release the switch stop the power cutter.
Power switch lock
The power switch lock is designed to prevent accidental
operation of the switch. Press the power lock switch (A)
to release the power switch (B).
The power switch lock remains released as long as the
power switch is released. When the grip on the handle is
released both the power switch and power switch lock
are reset. This movement is controlled by two
independent return springs. This position results in the
machine stopping and the power switch being locked.
Blade guard
This guard is fitted above the cutting blade and is
designed to prevent parts of the blade or cutting
fragments from being thrown towards the user.
397 - 001 -
Publicité
Chapitres
Table des Matières
