Husqvarna K 4000 Manuel D'utilisation page 13

Make sure the arbor bushings fit to the centre hole on
the cutting blade.
The product is supplied with either a fixed bushing or a
bushing that can be flipped over to fit either 20 mm or 1
in (25,4 mm) center holes.
• Make sure the bushing on the spindle shaft of the
product corresponds with the centre hole on the
cutting blade.
The blades are marked with the diameter of the
centre hole.
To examine the direction of the cutting
blade rotation
If a diamond blade is used, make sure that it rotates in
the direction indicated by the arrow on the blade.
• Examine the direction of the cuting blade rotation
shown by the arrows on the cutting arm.
To fit the cutting blade
The tightening torque for the bolt holding the cutting
blade is 25Nm (18,5ft-Ibs).
The cutting blade is placed on the bushing (A) between
the inner flange washer (B) and the flange washer (C).
The flange washer is turned so that it fits on the axel.
B
397 - 001 -
A
C
1. Lock the cutting blade/axel with the locking button on
the rear of the machine. The button is reset when
released.
To adjust the blade guard
WARNING: Always make sure that the blade
guard is correctly fitted before starting the
product.
The guard for the cutting equipment should be adjusted
so that the rear section is flush with the work piece.
Spatter and sparks from the cut material are then
collected by the guard and moved away from the user.
The blade guard is friction locked.
1. Press the ends of the guard against the work piece
or adjust the guard with the adjustment handle.
To adjust the splash guard
1. Slide the splash guard into the slots at the back of
the protective cover on the cutting blade.
13