EQUATION EF431LV-E Notice De Montage, Utilisation Et Entretien page 115

Les langues disponibles

7. REMOTE OPERATION

1. Boot steps

1) Connect the power

2) Turn on the power switch

3) Press the " " key of the remote controller to start up

4) Press the 1000W button for the 1000W heat settings; press twice to switch off

the heat setting.

5) Press the 2000W button for the 2000W heat settings; press twice to switch off

the heat setting.

6) Press the DIMMER button for operate the dimmer mode.

Room temperature control system with open window detection

1) Press the button " "or "F" on the fireplace, the heater will come into in the

working situation, open the heating function for some time.

2) Press the button "

3) When the fireplace heater detect the room temperature down suddenly, for

example, the window of the room is open, then the fireplace heater stop the

heating function, then the LED display showing of "

3) The heating function cannot operate during one hour by itself, but you can

press the button "

3. Setting the day and time

1) Settings are done on the remote controller

2) Press "DATE TIME" button, then press the "▲" or "

3) Press "DATE TIME" button again, then press the "+" or "-" to set the hour

4) Press "DATE TIME" button again, then press the "+" or "-" to set the minute

5) Press "OK" button to complete

4. Temperature setting

The default set temperature is 20°C, press "+" or "-" on the remote controller to

set the temperature, which ranges from 15 to 30°C. And this setting is only for the

temperature in the normally mode, not for the temperature in the timer mode.

5. Timer setting

1) Description of timer setting

There are up to 9 items for timer setting

Each setting item has its date, power-on time and shutdown time

115

" on the remote control, the LED display will show "

" again, exit the open window detection function.

" will blink.

" key to select the day

▼