Reactivating The Airbag System - Helite E-TURTLE Manuel D'utilisation

CAUTION
The use of the fork sensor is not recommended with the use of non-approved
accessories (exhaust pipe) and on a non-approved motorcycle. Some motorcycles
prepared only for the race track may exceed a too high vibration threshold and
mislead the sensor.
C. PRECAUTIONS BEFORE USING THE AIRBAG SYSTEM
If one of these conditions is not validated, you may not be protected
properly.
The vest is adjusted correctly to your size.
The e-cartridge must be new and properly connected to the system.
The 3 clips of the vest are closed.
The vest is sufficiently charged (green LED on).
The fork sensor is recognized by the vest.
The green LED is on and flashes.

7. Reactivating the airbag system

After activation, you can reuse the vest. Here are the steps to follow before reusing it
optimally.
See schema 6 on the schematic manual
1. Take off the vest.
2. Open the zip on the right front.
3. Remove the empty e-cartridge.
y a) Disconnect the e-cartridge.
y b) Unscrew the e-cartridge.
y c) Remove the e-cartridge with the cable.
4. Remove air from the vest with both hands.
5. Install a new e-cartridge.
y a) Slide the e-cartridge cable in the cylinder.
y b) Screw the e-cartridge.
y c) Connect the e-cartridge (cartridge symbol).
CAUTION Do not damage the cable while screwing the e-cartridge (e.g. by bending
it). Only connect the e-cartridge once it is entirely screwed (see example on the
scheme below).
6. Close the zip.
7. The vest can be reused.
User guide
!
For the steps 2 to
5 the vest must
always be
switched off.
27