Helite E-TURTLE Manuel D'utilisation page 23

See schema 4 on the schematic manual
1. Switch on the vest by pressing three times the button quickly. The LED flashes
green and you hear a beep.
2. Press the button for 3 seconds until the LED turns blue. Release the button and
go to the next step.
3. Place the magnet on the fork sensor over the round slot. Please note that you
only have 30 seconds to effect this procedure.
y If you hear a long beep: the vest and the fork sensor are paired.
y If you hear a short beep: the vest and the fork sensor have already been paired.
y If you hear several beeps (+ red LED): the pairing has failed. Either you have taken
more than 30 seconds to place the magnet over the sensor, or you already have 5
fork sensors associated with the vest. In the first case, repeat the pairing procedure.
In the second case, you must delete all the sensors associated with the vest (see
page 27).
B. Install the fork sensor on the motorcycle
See schema 5 on the schematic manual
1. Choose the right bracelet size
Try the different sizes. The right size has to be adjusted to the motorcycle fork. The
screw needs to be screwed into the nut of the bracelet.
2. Assemble the sensor and the bracelet
Caution: If other vests are paired to the sensor, they must be switched off.
Clip the wide side of the bracelet to the side of the fork sensor. Choose notch A or B to
adjust the strap to the size of your motorcycle fork.
3. Place the sensor on the fork
Caution: Make sure to thoroughly clean your fork before installing the sensor.
a) Place the sensor on the bottom of one of the fork sleeves of the motorcycle.
b) Add the shim if necessary to adjust the fork sensor.
c) Tighten the screw by using the nut. Do not tighten more than 1.5Nm to avoid breaking
the fork sensor (you can stop screwing when it gets difficult to turn the bracelet with
your hand).
C. Wear the vest
Put on the vest, adjust the straps to fit your size and close the three
clips for optimal airbag operation.
User guide
23