Aquasensor; Time Display; Sensor Setting; Extradry - Gaggenau DF250 Notice D'utilisation

AquaSensor *

* optional feature which may or may not be included
A q u a S e n s o r
with your dishwasher
The AquaSensor is an optical measuring device which
measures the cleanliness of the rinse water.
The AquaSensor is used according to the wash cycle. If
the AquaSensor is active, "clean" rinse water can be
transferred to the next rinse and water consumption can
be reduced by 0.8–1-5 gal (3–6 liters). If the rinse water
is not yet clear, the water is drained and is replaced with
fresh water. In the automatic wash cycles the
temperature and running time can also be adjusted to
the degree of soiling.

Time display

The wash cycle time is determined during the wash
cycle by the water temperature, the amount of dishes, as
well as the degree of soiling and may vary (depending
on the selected wash cycle). You can change the time
display into time of day or hours/minutes so that the
remaining cycle time of the wash cycle appears in the
display window "Finish at" (for example 15:20 o'clock)
or "Finish in" (for example 3:25 hours).

Sensor setting

The wash cycle sequence is optimized in Auto wash
cycles with the aid of sensors. The sensors adjust the
wash cycle strength of Auto wash cycles depending on
the amount and type of soiling. You can adjust the
sensitivity of the sensors in 3 stages.
Standard: This setting is ideal for a mixed load and
heavily soiled utensils, but also saves energy and water.
Sensitive: This setting adjusts the wash cycle strength
for the effective removal of food remnants, even if the
amount of soiling is low. The energy and water
consumption is adjusted accordingly.
Very sensitive: This setting adjusts the wash cycle
strength for difficult conditions of use, for example
firmly dried on food remnants. This setting is
recommended if using biological or eco detergents
which contain lower amounts of active agents. The
energy and water consumption is adjusted accordingly.
Operating the Dishwasher

extraDry

The final rinse uses a higher temperature which
improves the drying result. The cycle time may increase
slightly. (Caution if utensils are delicate!) You can
switch the extraDry function on or off. There is a slight
increase in energy consumption.

Eco forecast

When Eco forecast is activated, the average water and
energy consumption of the selected wash cycle is
briefly displayed in the digital display @.
AutoPowerOff
(Switching off automatically after the
end of the wash cycle)
T o save energy, the dishwasher is switched off 1 minute
A u t o P o w e r O f f
after the wash cycle ends. You can also change this
setting.
Possible settings are:
off: The appliance does not switch off automatically.
▯
After one minute: The appliance switches off after
▯
1 minute. This is the most energy efficient setting.
After two hours: The appliance switches off after
▯
2 hours.

Infolight *

W hile the wash cycle is running, a light spot shines
i n f o L i g h t
on the floor under the appliance door. Do not open the
appliance door until the light point is no longer visible
on the floor. If the appliance door is not completely
closed, the light spot flashes *. If the appliance
is installed at eye-level, with flush furniture front,
the light point is not visible. You can switch the Infolight
on or off.
In darkened rooms, some light scattering may be visible.
This is normal and cannot be changed.
* optional feature which may or may not be included with
your dishwasher.
en-us
31