Water Softening System / Special Salt; Water Hardness Table; Adjusting The Water Softening System - Gaggenau DF250 Notice D'utilisation

Water softening system / special salt

+
T o ensure good rinsing results, the dishwasher requires
W a t e r s o f t e n i n g s y s t e m / s p e c i a l s a l t
soft water, i.e. water which is low in lime, otherwise
limescale will be deposited on the utensils and interior
container. Tap water above 7° dH (1.2 mmol/l) must be
softened. The water is softened with special salt
(regeneration salt) in the water softening system
of the dishwasher. The setting and therefore the
required amount of salt depends on the degree of
hardness of your tap water (see following water
hardness table).

Water hardness table

Water softening system / special salt

Adjusting the water softening system

The amount of salt dispensed can be set from 0 to 62°E.
Salt is not required at the set value 0-8.
Set the softening system as follows:
1.
Ask your local water utility company for the water
hardness value of the tap water.
2.
Required setting can be found in the water hardness
table.
3.
Open the door.
4. Switch on ON/OFF switch (.
5. Press Info button ( 8 for 3 seconds until the
following text is indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with t 3 sec.
6. Keep pressing button > )* until the water hardness
is indicated on the display window at the top @.
7. Make the selection with setting buttons + - X.
Press and hold the Info button (8 for 3 seconds.
8.
The chosen setting has now been stored.
en-us
15