PERFECTPRO UBOX 100 Mode D'emploi page 8

Operating your radio – FM auto-tune
1. Straighten the antenna properly above the radio. Press
the Power On/Off button to switch on your radio.
2. Press and release the Source button until the FM (1 or 2)
band is selected.
3. To scan up in frequency, first rotate the Tuning control
knob in a clockwise direction and then press the
Tuning control knob. Your radio will scan in an upwards
direction (low frequency to high frequency) and stop
automatically when it finds a station of sufficient
strength. To scan down in frequency, first rotate the
Tuning control knob in a anti-clockwise direction and
then press the Tuning control knob. Your radio will
scan in a downwards direction and stop automatically
when it finds a station of sufficient strength. After a few
seconds the display will update. The display will show
the frequency of the signal found. If the signal is strong
enough and there is RDS data present then the radio
will display the station name.
4. When the waveband end is reached, your radio will
recommence tuning from the opposite waveband end.
5. Adjust the Volume control to the required setting.
6. To switch off your radio, press the Power On/Off button.
Note:
If you find the reception is poor, try repositioning the
antenna. It may be necessary to relocate your radio to a
position giving better reception and carry out a scan to
find stations.
7
Manual tuning – FM
1. Straighten the antenna.
2. Press the Power On/Off button to switch on your radio.
3. Press and release the Source button until the FM (1 or 2)
band is selected.
4. Rotate the Tuning control knob to tune to a station.
The frequency will change in steps of 50 kHz or 100
kHz. When the waveband end is reached, the radio will
recommence tuning from the opposite waveband end.
5. Adjust the Volume control to the required setting.
6. To switch off your radio, press the Power On/Off button.
Setting tuning step – FM
1. Press and hold the Info/Menu button to enter the menu
setting.
2. Rotate the Tuning control knob until "FACTORY" shows
on the display. Press the Tuning control knob to enter
the setting.
3. Rotate the Tuning control knob until "FM XK" shows on
the display. Press the Tuning control knob to enter the
setting.
4. Rotate the Tuning control knob to choose the desired
FM tuning step (50 kHz or 100 kHz).Press the Tuning
control knob to confirm the setting.