PERFECTPRO UBOX 100 Mode D'emploi page 14

Factory reset
If you wish to completely reset your radio to its initial state
this may be performed by following this procedure. By
performing a factory reset, all user entered settings will be
erased.
1. Press and hold the Info/Menu button to enter the menu
setting.
2. Rotate the Tuning control knob until "FACTORY" shows
on the display. Press the Tuning control knob to enter
the setting.
3. Rotate the Tuning control knob until "RESET" shows on
the display. Press the Tuning control knob to enter the
setting.
4. Rotate the Tuning control knob to select "YES" or "NO".
If you do not wish to carry out a system reset, select "No"
and then press the Tuning control knob to confirm the
setting.
5. With "Yes" selected, press the Tuning control knob
to confirm the setting. A full reset will be performed.
Presets will be erased. All the settings will be set to
their default values. In case of malfunction due to
electrostatic discharge, reset the product using the
above procedure. In some circumstances it may be
necessary to disconnect and then reconnect the mains
power in order to resume normal operation.
13
Software version
The software display cannot be altered and is just for your
reference.
1. Press and hold the Info/Menu button to enter the menu
setting.
2. Rotate the Tuning control knob until "FACTORY" shows
on the display. Press the Tuning control knob to enter
the setting.
3. Rotate the Tuning control knob until "VER XXX" (e.g.
VER 049) appears. Current software version is shown
on the display.
4. Press and release the Info/Menu button to exit the
software version display.