Abus TVAC71000 Manuel Utilisateur page 20

Warnings
Observe all safety and operating instructions before putting the device into operation for the first time.
1. Observe the following information to avoid damage to the power cable and plug:

Do not modify or manipulate the power cable or plug.

Do not bend or twist the power cable.

Do not pull the cable when disconnecting the device from the power – always take hold of the plug.

Ensure that the power cable is positioned as far away as possible from any heating equipment, as this could otherwise melt
the plastic coating.
2. Follow these instructions. Non-compliance with these instructions could lead to an electric shock.

Never open the housing or power supply unit.

Do not insert any metallic or flammable objects into the device.

Use overvoltage protection to prevent damage caused by overvoltage (e.g. electrical storms).
3. Disconnect defective devices from the power immediately and contact your specialist dealer.
During the installation into an existing video surveillance system make sure that all devices are disconnected from the low and
supply voltage circuit.
If in doubt allow a professional electrician to mount, install and wire-up your device. Improper electrical connection to the mains
does not only represent at threat to you but also to other persons.
Wire-up the entire system making sure that the mains and low voltage circuit remain separated and cannot come into contact
with each other in normal use or due to any malfunctioning.
Unpacking
While you are unpacking the device please handle it with utmost care.
If you notice any damage of the original packaging, please check at first the device.
If the device shows damages, please contact your local dealer.
20
English