VOLTCRAFT B6 Ultimate Notice D'emploi page 96

BATTERY VOLTAGE BATTERY VOLTAGE BATTERY VOLTAGE
BATTERY VOLTAGE BATTERY VOLTAGE
CELL HIGH VOL CELL HIGH VOL
CELL HIGH VOL CELL HIGH VOL CELL HIGH VOL
BATTERY BATTERY
BATTERY BATTERY BATTERY
CELL CONNECT CELL CONNECT CELL CONNECT
CELL CONNECT CELL CONNECT
TEMP OVER ERR TEMP OVER ERR
TEMP OVER ERR TEMP OVER ERR TEMP OVER ERR
CONTROL FAILURE CONTROL FAILURE CONTROL FAILURE
CONTROL FAILURE CONTROL FAILURE
96
VOLTAGE VOLTAGE
VOLTAGE VOLTAGE VOLTAGE
The voltage in one of the cells of a lithium
battery (LiPo, LiIon, LiFe) is too high. This can
occur if a multi-cell battery was previously
charged without a balancer.
The balancer cable was connected wrong or
does not fit to the pin assignment of the charger.
Excess temperature detected. Leave the
charger and the battery to cool down.
The charger has identified an internal problem.
Should this message permanently be displayed,
it is possible that the charger is defective; have it
checked by a specialist workshop or qualified
technician.