Various Basic Settings ("User Set") - VOLTCRAFT B6 Ultimate Notice D'emploi

16. VARIOUS BASIC SETTINGS ("USER SET")

• In the main menu, select the "USER" menu with the "TYPE/STOP" button.
USER SET USER SET USER SET
USER SET USER SET
• Press the button "ENTER/START"; the display shows the following, for example:
LiFe LiFe
LiFe LiFe LiFe
V.Type V.Type V.Type
V.Type V.Type
Here you can select one of the three lithium battery types the charger is able to work
with ("LiPo", "LiIo", "LiFe").
• Briefly press the button "ENTER/START". The voltage value then begins to flash.
With the buttons "INC" or "DEC", you can select the cell voltage "3.3", "3.6" or "3.7". At
the same time, the corresponding battery type changes in the top line.
Confirm the selection of the lithium battery type with the button "ENTER/START", and the
voltage value stops blinking.
The settings made here for the lithium battery type then applies for ALL other
functions, e.g. charging, discharging, etc. (see chapter 11).
• With the button "INC", switch to the next setting (or to the previous one with the button
"DEC").
LiPo/LiIo/LiFe LiPo/LiIo/LiFe LiPo/LiIo/LiFe
LiPo/LiIo/LiFe LiPo/LiIo/LiFe
CHK Time CHK Time
CHK Time CHK Time CHK Time
Here you can set the time in which the charger checks a connected lithium battery for
the correct cell count and terminates the charge process, if applicable.
This may be especially helpful with deep discharged batteries. For a battery with a
higher capacity set a longer time; for one with a lower capacity set a correspondingly
shorter time.
Briefly press the button "ENTER/START". The time then begins to flash. With the buttons
"INC" or "DEC", you can select the time (5 to 60 minutes). Save the setting with the
button "ENTER/START"; the time stops blinking.
86
PROGRAM-> PROGRAM->
PROGRAM-> PROGRAM-> PROGRAM->
3.3V 3.3V 3.3V
3.3V 3.3V
10min 10min
10min 10min 10min