VOLTCRAFT B6 Ultimate Notice D'emploi page 68

• When connecting a battery to the charge, always connect the charging cable
to the charger first, then the battery to the charger/charging cable. When
disconnecting, proceed in reverse order (first disconnect the rechargeable
battery from the charging cable, then the charging cable from the charger).
Failure to do so presents the danger of a short circuit (e.g. from the two 4mm
circular connectors on the charging cable).
• Only ever charge one battery or battery pack at a time.
• If you wish to charge battery packs that you have manufactured yourself, the
cells must be identical in their construction (same type, same capacity, same
manufacturer). The cells must also be charged to the same level (LiPo
batteries can be balanced out using the balancer, this is, however, not
possible with other battery packs such as NiMH or NiCd).
General operation of the menus (overview see chapter 10):
• Select the desired submenu from the main menu using the "TYPE/STOP" key as de-
scribed and confirm your selection with the key "ENTER/START".
• Using the buttons "INC" and "DEC", the various configuration options are called up.
• To modify a value, press the "ENTER/START" key - the display then flashes.
• Modify the value shown in the display using the "INC" and "DEC" buttons.
• Save the (modified) value with the "ENTER/START" button.
• Exit the configuration menu using the "TYPE/STOP" button. It then returns to the main
menu.
68