Scheppach Slik 5.0b Manuel page 14

Problem
Motor does not start up.
Sanding belt slides through
Sanding belt does not run evenly
Sanding belt runs in the wrong
direction
Warning symbols
Wear proper work shoes and gloves!
Wear safety goggles!
Read manual!
14 english
Trouble shooting
Possible Cause
– no electricity
– capacitor and/or switch defective
– extension cord defective
– sanding belt stretched after long
use
– pinch pin is not correctly installed
– too much pressure downwards
– sanding belt is defective or torn
– sanding belt is stretched after long
use
– wrong direction in the rotary motor
Solution
– check fuses
– allow an expert to check capacitor
and switch
– unplug the machine, check and
replace, if necessary, the extension
cord if necessary
– put on a new sanding belt
– turn the pinch pin exactly
– move the work piece while it is
being sanded
– check, replace
– replace the sanding belt with a new
one
– let an electrician check the polarity
of the wall socket
Warning: remove mains fuse!