DeWalt DW432 Mode D'emploi page 27

Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power
input of this tool (see technical data).The minimum
2
conductor size is 1.5 mm ; the maximum length is
30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Fitting and Centring the Sanding Belt
(fi g. B1, B2)
The tool uses 75 x 533 mm sanding belts.
1. Turn the clamping lever (7) clockwise until it is in
the release position.
2. Remove the sanding belt (10).
3. Place a new sanding belt making sure that the
arrow on the inside of the sanding belt points
in the same direction as the arrow on the
machine.
4. Turn the clamping lever counter-clockwise until
it is in the clamp position.
5. Switch the machine on and turn the belt
centring knob (8) until the sanding belt is
centred on the roller (6).
Adjusting the Front Handle (fi g. C)
The position of the front handle can be adjusted for
optimum control. The default position is on top of
the tool.
1. Loosen the screw (11) located in the centre of
the front handle (3).
2. Take the handle from the socket and place it on
the alternative socket either on top (12) or on
the front (13) of the tool.
3. Make sure that the handle is properly seated.
4. Tighten the screw.
DW433 - Setting the Electronic
Speed Control (fi g. A)
The belt speed is infinitely variable from 260 to
420 m/min using the electronic speed control
dial (5).
Turn the electronic speed control dial to the required
level. The correct setting, however, is a matter of
experience.
Generally, harder materials require a higher setting.
Dust Extraction (fi g. D1, D2)
WARNING: Since woodworking with a
sander produces dust, always install a
dustbag designed in compliance with
the applicable directives regarding dust
emission.
WARNING: Do not use a dustbag or
vacuum extractor without proper spark
protection when sanding metal.
1. Slide the dustbag (9) onto the adaptor (14) over
the edges (15).
2. Pull the locking collar (16) up.
3. Locate the rim (17) behind the edge (18).
4. Align the lugs (19) with the recesses (20).
5. Firmly push the adaptor (14) into the dust
extraction outlet (21) until it clicks in place.
6. Push the locking collar down.
Dust Extraction Shut-off
The dust extraction system can be disabled by
activating the dust extraction shut-off valve. This will
prevent the dust being blown toward the operator.
To close the valve, push the switch (4) forward.
To open the valve, pull the switch backward.
WARNING: While using the dustbag,
always make sure the dust extraction
shut-off valve is open.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
EN G LI SH
25