Manual Nozzle Cleaning; Clean Print Cartridge Contacts; Clean Protective Nozzle Seal - Reiner jetStamp graphic 970 Mode D'emploi

jetStamp graphic 970

5.1.2. Manual Nozzle Cleaning

Manual nozzle cleaning
When the automatic nozzle cleaning does not lead to the desired success,
we recommend the following measure:
To loosen the dried ink, gently wipe a soft cloth possibly moistened slightly with
f
Ethanol (spirit) against the nozzles for approx. three seconds
Dab off dissolved ink and wipe the nozzles
f

5.2. Clean Print Cartridge Contacts

Clean print cartridge contacts
In rare case, contamination of the print cartridge contacts
results.
Put the jetStamp graphic 970 in the base station
f
Turn the setting wheel
f
Keep the trigger button
f
Print carriage
Gently push the lock of print cartridge
f
11
be opened.
Open print cartridge flap
f
Remove the print cartridge
f
Clean the print cartridge contacts
f
print cartridge flap
Put down device on a fixed underground.
f
Insert printing cartridge
f
Close the print cartridge flap
f
Push the trigger button
f
Print carriage

5.3. Clean Protective Nozzle Seal

Clean Protective Nozzle Seal
The Protective Nozzle Seal
Dab the Protective Nozzle Seal
f
Clean the Protective Nozzle Seal
nation or damage (see "Replace Protective Nozzle Seal" Page 67).
66
Fig. +
D

Fig.

7
to position 1.
1
pushed and take the device from the base station
3
moves to the middle position.
11
.
12
.
14
11
with a soft cloth possibly moistened slightly with ethanol (spirit).
12
.
11
.
1
.
3
moves to the home position.
Fig.

5
is located in the base station
5
clean with a soft cloth.
E
15
dry.
A + B + D
14
4
.
13
to the right, until the print cartridge flap can
at the print cartridge
A + D +
4
.
5
at regular intervals. Replace at stronger contami-
15
.
may cause defective print
4
.
12
and the