Electrical Connection - Burkert 0450 Instructions De Service

Electrical connection

Pilot valve Type 6106:
• Read the voltage, power rating and type of protection and current
from the nameplate!
• Voltage tolerance: ±10 %
• Use 10 mm filter to assure a long service life of the pilot valve!
• Electrical connection: cable connector Type 2506 onto the plug
connector of the coil (fixing torque: 0.4 Nm)
• Protection Type IP65 (only in connection with cable connector Type
2506).
• The cable connector may be mounted turned by 180° to suit the cable
direction.
The coil heats up in operation!
NOTE
ATTENTION!
Observe the voltage: with AC be sure to
use the cable connector Type 2506 or
connect a rectifier between!
On screwing the cable connector to the
coil, make sure the flat seal is properly
seated!
Example
10 µm
Alwys connect the
protective conductor!
flat seal
T D
ECHNICAL ATA
0,4 Nm
Type 2506
8640-0450 - 9