Fonctionnement - Husqvarna ER 105 Manuel D'utilisation

Introduction
AVERTISSEMENT: Lire et comprendre le
chapitre sur la sécurité avant d'utiliser le
produit.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Do the daily maintenance. Refer to
schedule à la page 65 .
Centrifugal force ER 105
The centrifugal force is not adjustable for ER 105.
Type, 3000 rpm, 50 Hz
ER 105
Type, 3600 rpm, 60 Hz
ER 105
To adjust the centrifugal force ER 205
1. Remove the bolts and washers that hold the end
To disassemble the product à la
covers. Refer to
page 66 .
2. Remove the end covers.
3. Remove the bolts and the washers from each end of
the rotor.
4. Remove the eccentric weights from the shaft and
turn them 180° to adjust the centrifugal force. Refer
Eccentric weight adjustments for ER 205, 50 Hz à
to
la page 62 and Eccentric weight adjustments for
ER 205, 60 Hz à la page 62 .
MISE EN GARDE : Do the adjustments
on each end of the rotor.
Remarque : The positions of the eccentric weights
are also found on the inner side of the eccentric
weights covers. The factory positions for the
products are set to position 4.
5. Assemble the product. Refer to
product à la page 66 .
62

Fonctionnement

Maintenance
Centrifugal force, N
500
Centrifugal force, Lbs
118
To assemble the
Eccentric weight adjustments for ER
205, 50 Hz
1 2
Type, 3000 rpm
ER 205 155
Position 1
Eccentric weight adjustments for ER
205, 60 Hz
1 2
Type, 3600 rpm
ER 205
Position
To adjust the centrifugal force ER 305,
ER 405 and ER 505
1. Remove the bolts and washers that hold the end
To disassemble the product à la
covers. Refer to
page 66 .
2. Remove the end covers.
3. Remove the bolts and the washers from each end of
the rotor.
4. Remove the eccentric weights from the shaft and
turn them 180° to adjust the centrifugal force. Refer
Eccentric weight adjustments for ER 305, ER 405
to
and ER 505, 50 Hz à la page 63 and Eccentric
weight adjustments for ER 305, ER 405 and ER 505,
60 Hz à la page 63 .
MISE EN GARDE : Do the adjustments
on each end of the rotor.
3 4
Centrifugal force, N
470 780 1100 1400
2 3 4
3 4
Centrifugal force, Lbs
48 144 240
1 2 3
1586 - 001 - 26.03.2021
5
5
336
4